Table of Contents
Advertisement
I
<Esc>-I
SET VERTICAL TAB AT CURRENT POSITIOl'
This command is used to set the individual vertical tab
stops. Move the current position to the desired tab posi-
tion by issuing the required number of
<LF>
commands.
The height of each line is determined by the VMI. Issue
the above command at the current position
to
set the tab
stop. To determine the desired tab stop positions, use the
following formula:
Vertical Tab
=
(Vertical Position7 VMI)+l
The "Vertical Tab" will be the number of the vertical tab
stop
(1 -
126). "Vertical Position" is a whole number
expressing the number of 1/48 inch increments from the
top edge of the page.
[<E§C>8l
CLEAR HORIZONTAL TAB
This command is used to clear a tab stop at the current
position.
I
<ESC>21
CLEAR ALL VERTICAL AND
HORIZONTAL TABS
When this command is issued, all vertical and horizontal
tab stops will be cleared.
I
<ESC>C
I
CLEAR TOP AND BOTTOM MARGINS
Use this comm'and to clear the Top and Bottom Margins
and return them to the default margins.
0-16
Diablo Emulation Mode
\
\
Advertisement
Table of Contents
