Table of Contents
Advertisement
I
<LF>
I
LINE FEED
This command moves the print position down one Line
Space. The actual distance of the Line Space is estab-
lished by setting the Vertical Motion Index or the Alternate
Vertical Motion Index. The Line Spacing will also be af-
fected if Graphics Mode is "ON". Line Spacing will then
be either 1/60 inch or 1/120 inch. If Underscore Mode is
"ON", the Line Feed command will turn it "OFF".
I
<SP>
I
SPACE
Using the Space Command will move the print position
one column width, usually, to the right. The width of the
column will depend on the current pitch (10, 12, or 15),
the Horizontal Motion Index or its Alternate command,
the Right Margin setting and Graphics Mode "ON"
(1/60
inch or
1/120
inch). If Backward Printing is "ON", a
Space command will actually cause the print position to
move one column width to the left.
C.2
Formatting Commands
The Formatting Commands are used to define the parame-
ters of printed material on a page. Be sure to consider the
current paper size and page orientation when you establish
these parameters.
• SET TOP MARGIN
• SET BOTTOM MARGIN
• SET LEFf MARGIN
• SET RIGHT MARGIN
• VERTICAL MOTION INDEX is used to establish
~
the line spacing value.
G-8
Qume Emulation Mode
Advertisement
Table of Contents
