Table of Contents
Advertisement
• Blank Print
1. Increase the print density by using the print den-
sity adjustment dial on the left side of the printer.
2. Remove the print cartridge and rotate it as you
do before installing a new cartridge. This redis-
tributes the toner inside the print cartridge.
3.
If
the cartridge indicator is red, replace the car-
tridge.
If it
is not red, make sure the sealing
tapes are properly removed from the cartridge.
4. Place a service call (see the end of this section).
• Black Image (entire page)
1. Remove the print cartridge and rotate it as you
would when installing a new cartridge. This re-
distributes the toner inside the print cartridge.
2. Install a new print cartridge.
• Stain Along Right Edge of Page
1. Clean the separation belt (see Section E.1).
2. Install a new print cartridge.
CJ
Stains On Back of Page
1. Clean the area around the manual paper feed slot
at the rear of the printer with a damp cloth. Dry
the area.
2. Clean the corona wires and the surrounding area
(see Section
C.1).
Emphasize cleaning the un-
derside of the print cartridge.
3. Inspect the fixing assemply cleaner. If it is dirty,
replace it (see Section
B.1).
Maintenance and Troubleshooting
5-19
Advertisement
Table of Contents
