Table of Contents
Advertisement
• SET LEFr MARGIN
• SET RIGHT MARGIN
• SET HORIWNTAL TABS establishes up to 32 dif-
ferent horizontal tab stops in one command.
• HORIZONTAL TAB moves the current position to
the next horizontal tab stop.
• SET VERTICAL TABS establishes up to 16 different
vertical tab stops in one command.
• VERTICAL TAB moves the current position to the
next vertical tab stop.
• DEFINE VERTICAL TAB CHANNELS establishes
up to 16 different vertical tab stops in each of eight
different channels.
• SELECT VERTICAL TAB CHANNEL 'x' selects
the vertical tab channel to be used.
I
<ESC>I<n>
I
SET LEFT MARGIN
The <ESC>1
(lower-case ilL")
establishes the left margin
at the column number specified by 'n'. The valid values
for on' in the command depend on the Print Mode in use.
If Pica Print Mode is used, the range of values for 'n'
are 0-78. In Elite Mode, the values for 'n' are 0-93. In
Compressed Mode, the values for on' are 0-133. Any
other values are ignored. New margins do not go into
effect until after the next <CR>. Once the left margin is
established, it remains in effect until changed by a new Set
Left Margin command or until the printer is powered-off.
The left margin setting is not affected by the Print Width.
The Set Left Margin command clears the printer buffer
when it is received. Do not issue the Set Left Margin
command at the END of a line.
Changing the left margin will affect the horizontal tab
Appendix E
E-25
Advertisement
Table of Contents
