QMS SmartWriter 80+ User Manual page 308

Table of Contents

Advertisement

These software commands are explained in detail in Part
IV of this manual.
When using the supported commands, refer to the ASCn
conversion table in Appendix B at the back of this manual
to
determine the value for "n" in those commands which
require variable parameters. Use the appropriate conver-
sion value (ASCII, Hex, Decimal, etc.) required by your
computer system and the programming language being
used.
A
Supported Proprinter Com-
mand Summary
There are ten categories of supported Proprinter Emulation
Mode commands: Print Modes, Horizontal Movement,
Vertical Movement, Tabs, Page Format, Line Spacing, Bit
Image Graphics, Printer Control, Character Selection, and
Download Fonts. The supported commands are listed on
the next few pages as a means of quick reference. The
meanings of the categories and the commands will be ex-
plained later in this section.
Print
Mode Commands
<SI>
or Condensed Mode ON
<ESC><SI>
<DC2>
<ESC>-l
<ESC>-O
<ESC>:
<ESC>E
<ESC>F
<ESC>G
<ESC>H
<ESC>SO
<ESC>Sl
<ESC>T
<ESC>_l
<ESC>_O
F-2
Condensed Mode OFF (return to 10
Characters Per Inch)
Begin Continuous Underscore
Cancel Continuous Underscore
Set 12 CPI
. Start Emphasised Printing
Cancel Emphasised Printing
Begin Double Strike Printing (NLQ)
Cancel Double Strike Printing (NLQ)
Begin Superscript Printing
Begin Subscript Printing
Cancel Subscript or Superscript Printing
Begin Continuous Overscore
Cancel Continuous Overscore
Proprinter Emulation Mode
A
(
\,

Advertisement

Table of Contents
loading

Table of Contents