Table of Contents
Advertisement
Appendix G
Qume
Emulation Mode
Introduction
The QMS laser printer emulates the Qume®Sprint 9/45,
Sprint 9/55, and the Sprint 11 Plus letter-quality print-
ers. This section covers the commands that are supported
whenever the QMS printer is in Qume Emulation Mode.
If
you are using a word processor, you do not need to
read this section. Once your word processor is correctly
installed and is configured to work with a printer that em-
ulates a Qume printer, you may use your word processor
commands to edit and send your files
to
the QMS printer.
The explanations of the supported Qume commands are
given for those of you who may be writing computer pro-
grams and must actually use these commands. Qume com-
mands which are not supported by the QMS printer gener-
ally are required for the Qume printer to overcome certain
hardware limitations.
In addition to the commands explained in this section,
there are Printer Software Commands that are also hon-
ored when in Qume Emulation Mode. These are soft-
ware commands which allow you to change fonts, change
emulation modes, change page orientation, change paper
source, change the copy count, access the Extended Printer
Control or redefine the command or font translation ta-
bles. The software commands are a special feature of the
QMS printer and are very useful. These commands are
explained in Part IV of this manual.
Qume Emulation Mode
0-1
Advertisement
Table of Contents
