Table of Contents
Advertisement
Emulation Problems
Emulation Error
If you receive an emulation error, you may need to increase the amount
of memory for the K Mem For Emulation memory client. See chapters
4, "Printer Configuration," and 5, "Additional Technical Information," in
the Reference for more information on the Emulation memory client.
PostScript Print Job Doesn't Print
If the printer port is set for PostScript or ESP, increase the PS Heap
value (Administration/Memory/PS Heap menu) to at least 1536 KB and
reprint the job. See chapters 4, "Configuration Menu," and 5, "Additional
Technical Information," in the Reference for more information on PS
Heap.
PostScript Level 1 Problems
If you're using a Level 1 driver in your application and you have trouble
printing PostScript files, try printing the files with the PostScript level
set to Level 2 (Administration/Emulations/PostScript menu). See chap-
ter 4, "Printer Configuration," of the Reference for more information.
Font Problems
Can't Access Downloaded Fonts
n
Have you recently performed a system upgrade (release 2.0
or later firmware) on your QMS 1660 Print System and are
now unable to access your downloaded fonts?
Some fonts stored on your printer's hard disk are copy-protected.
Therefore, when you upgrade the system software (release 2.0 or
later firmware), these fonts must be downloaded again for the
Troubleshooting
Emulation
Problems
6-25
Advertisement
Table of Contents
