Table of Contents
Advertisement
to access two special character codes which cannot
normally be printed.
• GRAPHICS "ON" 1/60" cause the Space and Backspace
commands to move the current position 1/60 inch.
• GRAPHICS "ON" 1/120" causes the Space and Backspace
commands to move the current position 1/120 inch.
• GRAPHICS "OFF" disables the above two commands.
I
<ESC><SUB>I
I
TOTAL RESET/RESTORE
U sing this command will cause the printer to be returned
to ALL the default conditions. It has the same results as
turning the printer "OFF" and then back "ON" except that
no data is lost by using the Reset command. Subsequent
printing will begin on the next page.
I
<ESC><CR>P
I
ALTERNATE TOTAL RESET/RESTORE
This command may be used as an alternate to the above
command. The results are the same. ALL the default
conditions are reset.
I
<ESC>S
I
NO PRINT "ON"
This command allows words, such as passwords, to be
entered but not printed (masked).
I
<ESC>T
I
NO PRINT "OFF"
This command turns No Print "OFF".
Qume Emulation Mode
G-29
Advertisement
Table of Contents
