Table of Contents
Advertisement
• VARIABLE LINE SPACE causes a line feed
ofn/216
inches.
I
<VT>
I
VERTICAL TAB
This command (decimal 11) moves the current print po-
sition to the next vertical tab stop. You can skip over tab
stops by sending < VT> commands with no text until the
desired tab stop is reached.
I
<FF>
I
FORM FEED
This command (decimal 12) allows you to execute a Form
Feed without having to take the printer off-line and use the
I
FORM FEED
I
key.
I
<LF>
I
LINE FEED
This command (decimal 10) causes the printer to execute
a line feed.
\
I
<ESC>21 START TEXT LINE SPACING
Begins line spacing at the value set by <ESC>A (see "Line
Spacing Commands"). If no <ESC>A sequence has been
entered, line spacing will be 6 LPI (lines per inch).
I
<ESC>J<n>
I
VARIABLE LINE FEED
(n/216)
This command causes an line feed of n/216 inch (n x
0.12 mm). The value of n must be between 1 and 255.
Use a line spacing of 24/216 inch for bit-image graphics,
using eight bits. Use exact multiples of 3
to
move the
print position exactly n/216 inch. The <ESC>] command
is valid for one line only. The printer is returned to the
current line spacing after the command is acted on.
F-14
Proprinter Emulation Mode
Advertisement
Table of Contents
