Table of Contents
Advertisement
I
<ESC>Q<n>
I
SET RIGHT MARGIN
This command establishes the right margin at the column
number specified by on'. The valid values for on' depend
on the Print Mode in use.
If
Pica Print Mode is used, the
range of values for on' are 2-80. In Elite Mode, the values
for 'n' are 3-96. In Compressed Mode, the values for
on' are 4-l37. The right margin must always be greater
than the left margin or the printer will ignore the right
margin. Changing the Print Width may require changing
the right margin in order to maintain an even right hand
edge. The Set Right Margin command should be sent
AFTER changing or selecting Elite or Compressed Print
Widths.
Examples:
<ESC>QF Set Right Margin at column 70.
<ESC>QP Set Right Margin at column 80.
The Right Margin may also be set by using the keypad to
configure Group 4 Options 5, 6, 7, and 8. Refer to Section
9 for details of these Options.
I
<ESC>D<nl><n2> ... <n 32 ><NUL>
I
SET HORIZONTAL
TABS
This command is used to specify up to 32 columns for
setting horizontal tabs. This command does not move
the current print position. The valid values for On' in the
command are: 0-79 in Pica Mode, 0-95 in Elite Mode,
and 0-131 in Compressed Mode. In the command, nl
represents the column location for the first tab stop, n2
represents the column location for the second tab stop,
etc.
A horizontal tab cannot be larger than the maximum col-
umn for the Print Width being used. Tabs will remain in
effect until changed by a new <ESC>D command or un-
til the printer is powered-off. A Master Reset Code will
delete existing tabs and establish the default tabs which
are located every eight Pica columns.
Appendix E
E-27
Advertisement
Table of Contents
