Table of Contents
Advertisement
I
<ESC>C<NUL><n>
I
SET FORMS LENGTH TO
'n'
INCHES
This command is used to set Forms Length in terms of the
desired number of inches per page. The valid range for
en' in the command depends on the;'; size of paper being
used. For letter size paper, the range is 1-11. For legal
size paper, the range is 1-14.
If
this command is sent at
the Top Margin, it will establish a Bottom Margin and act
as a Skip-over-Perforation command.
Examples:
<ESC>C<NUL><VT>
Set Forms Length to 11"
<ESC>C<NUL><ENQ>
Set Forms Length to
5"
I
<ESC>C<n>
I
SET FORMS LENGTH TO
'n'
LINES
This command is used to set Forms Length in terms of the
desired number of lines per page. The number of lines per
page combines with the number of lines per inches to de-
termine the number of lines per inch. The valid range
for en' in the command is 0-127.
If
the number of lines
per page exceeds the size of the paper, the forms length
will automatically be set at the bottom of the paper.
If
this command is sent at the Top Margin, it will estab-
lish a Bottom Margin and act as a Skip-over-Perforation
command.
Examples:
<ESC>CB
Set Forms Length to 66 lines
<ESC>C<CAN>
Set Forms Length to
24
lines
I
Formatting Commands
The Formatting Commands are used to position the printed
material on the page as desired.
Remember that Pica
Mode (10 CPI) is the default Print Width. Elite Print
Mode has 12 CPI and Compressed Print Mode has 17
CPI.
E-24
Appendix E
\
Advertisement
Table of Contents
