QMS SmartWriter 80+ User Manual page 233

Table of Contents

Advertisement

Appendix D
Diablo 630
Emulation Mode
Introduction
The QMS laser printer emulates the Xerox® 1730/Diablo®
630 model letter-quality printers. References made in this
manual to the Diablo 630 also apply to the Xerox 1730.
This appendix covers commands supported by the QMS
printer whenever it is in Diablo Emulation Mode.
If
you are using a word processor, you do not need to
read this section. Once your word processor is correctly
installed and is configured to work with a printer that em-
ulates a Diablo 630, you may use your word processor
commands to edit and send your files to the QMS printer.
The explanations of the supported Diablo commands are
given for those of you who may be writing computer pro-
grams and must actually use these commands. Diablo
commands which are not supported by the printer gener-
ally are required for the Diablo 630 printer to overcome
certain hardware limitations.
In addition to the commands explained in this section,
there are Printer Software Commands that are also hon-
ored when in Diablo Emulation Mode. These are soft-
ware commands which allow you to change fonts, change
emulation modes, change page orientation, change paper
source, change the copy count, access the Extended Printer
Control or redefine the command or font translation tables.
The software commands are a special feature of the QMS
printer and are very useful. These commands are covered
in Part IV of this manual.
Diablo Emulation Mode
D-1

Advertisement

Table of Contents
loading

Table of Contents