Table of Contents
Advertisement
Line Spacing
6 lines/inch
8 lines/inch
I
<ESC>&lnl C
I
Set VMI
Escape Sequence
<ESC>&16D
<ESC>&ISD
This command is identical to the previous one, except that
the line spacing is specified in units of 1/48-inch. Parame-
ter
nl
is the desired value, in the range 0 through 126. You
can specify up to four decimal places of precision. For
example, the command
<ESC>&14.SC
would set the line
spacing to 0.1 inches.
I
<ESC>&kn1H
I
Set HMI
This commands changes the horizontal space allocated to
each printed character (including spaces). Parameter
nl
specifies the desired spacing in units of lII20-inch. This
value must be in the range 0 to 126, and may have up to
four decimal places of precision. For example:
Pitch
10 chars/inch
12 chars/inch
15 chars/inch
17 chars/inch
Escape Sequence
<ESC>&kI2H
<ESC>&kl0H
<ESC>&k8H
<ESC>&k7.0588H
This command can be used to print a 10 char/inch font at
12 char/inch,
or
vice versa.
If the current font is proportionally spaced, this command
only affects the width of the space character.
Horizontal spacing is defaulted to the current font pitch
when any of the following print parameters are changed:
Page orientation
Character set
Print pitch
Proportional spacing
HP Emulation Mode
H-19
Advertisement
Table of Contents
