Ipv6 Bidir-Pim Configuration Example - HPE FlexNetwork 5510 HI Series Configuration Manual

Group/MaskLen: FFF4::/16
RP address
1002::2 (local)
Group/MaskLen: FF04::/16
RP address
1002::2 (local)
# Display RP information on Switch F.
[SwitchF] display ipv6 pim rp-info
BSR RP information:
Scope: non-scoped
Group/MaskLen: FF00::/8
RP address
8001::1 (local)

IPv6 BIDIR-PIM configuration example

Network requirements
As shown in
• OSPFv3 runs on the network.
• VOD streams are sent to receiver hosts in IPv6 multicast.
• Source 1 and Source 2 send IPv6 multicast data to IPv6 multicast group FF14::101.
• Host A and Host B are receivers of this IPv6 multicast group.
• VLAN-interface 102 of Switch C acts as a C-BSR. Loopback 0 of Router C acts as the C-RP.
• MLDv1 runs between Switch B and Host A, and between Switch D and Host B.
Figure 107 Network diagram
Receiver 1
Host A
Source 1
Table 21 Interface and IPv6 address assignment
Device
Switch A
Switch A
Figure 107:
Switch B
Vlan-int200
Vlan-int101
Vlan-int101
Vlan-int100
Switch A
Interface IPv6 address
Vlan-int100 1001::1/64
Vlan-int101 1002::1/64
Priority HoldTime
192 180
Priority HoldTime
192 180
Priority HoldTime
192 180
Vlan-int102 Vlan-int102
Vlan-int103
IPv6 BIDIR-PIM
Vlan-int103
Device
Switch D
Switch D
319
Uptime Expires
00:02:03 00:02:56
Uptime Expires
00:02:03 00:02:56
Uptime Expires
00:10:28 00:02:31
Loop0
Switch C
Vlan-int400
Switch D
Interface IPv6 address
Vlan-int300 4001::1/64
Vlan-int400 5001::1/64
Receiver 2
Host B
Source 2