Configuring The Switchover To Spt; Configuring Bidir-Pim; Bidir-Pim Configuration Task List - HPE FlexNetwork 5510 HI Series Configuration Manual

Step
Enter system view.
1.
Enter PIM view.
2.
Configure a PIM register
3.
policy.
Configure the device to
4.
calculate the checksum
based on the entire register
message.
Configure the register
5.
suppression time.

Configuring the switchover to SPT

CAUTION:
If the device is an RP, disabling the switchover to SPT might cause multicast traffic forwarding
failures on the source-side DR. When disabling the switchover to SPT, make sure you fully
understand its impact on your network.
To configure the switchover to SPT:
Step
Enter system view.
1.
Enter PIM view.
2.
Configure the RPT to SPT
3.
switchover.

Configuring BIDIR-PIM

This section describes how to configure BIDIR-PIM.

BIDIR-PIM configuration task list

Tasks at a glance
(Required.)
(Required.)
• Configuring a static RP
• Configuring a C-RP
• (Optional.)
• (Optional.)
Configuring a
• (Required.)
• (Optional.)
Enabling BIDIR-PIM
Configuring an RP:
Enabling Auto-RP listening
Setting the maximum number of BIDIR-PIM RPs
BSR:
Configuring a C-BSR
Configuring a PIM domain border
Command
system-view
pim [ vpn-instance
vpn-instance-name ]
register-policy ipv4-acl-number
register-whole-checksum
register-suppression-timeout
interval
Command
system-view
pim [ vpn-instance
vpn-instance-name ]
spt-switch-threshold
{ immediacy | infinity }
[ group-policy ipv4-acl-number ]
125
Remarks
N/A
N/A
By default, no PIM register policy
exists, and all PIM register
messages are regarded as legal.
By default, the device calculates
the checksum based on the
header of a register message.
The default setting is 60 seconds.
Remarks
N/A
N/A
By default, the first multicast data
packet triggers the RPT to SPT
switchover.
Remarks
N/A
You must configure a static RP, a
C-RP, or both in a BIDIR-PIM
domain.
Skip the task of configuring a BSR
on a network without C-RPs.