Displaying And Maintaining Ipv6 Pim Snooping; Ipv6 Pim Snooping Configuration Example; Network Requirements - HPE FlexNetwork 5510 HI Series Configuration Manual

Step
ports on the new master
device after a
master/subordinate
switchover.
(Optional.) Set the aging
8.
time for global
downstream ports and
global router ports on the
new master device after a
master/subordinate
switchover.

Displaying and maintaining IPv6 PIM snooping

Execute display commands in any view and reset commands in user view.
Task
Display IPv6 PIM snooping neighbor
information.
Display IPv6 PIM snooping router
port information.
Display IPv6 PIM snooping routing
entries.
Display statistics for the IPv6 PIM
messages learned through IPv6 PIM
snooping.
Clear statistics for the IPv6 PIM
messages learned through IPv6 PIM
snooping.

IPv6 PIM snooping configuration example

Network requirements

As shown in
• OSPFv3 runs on the network.
• Source 1 and Source 2 send IPv6 multicast data to IPv6 multicast groups FF1E::101 and
FF2E::101, respectively.
• Receiver 1 and Receiver 2 belong to IPv6 multicast groups FF1E::101 and FF2E::101,
respectively.
• Router C and Router D run MLD on GigabitEthernet 1/0/1.
• Router A, Router B, Router C, and Router D run IPv6 PIM-SM. GigabitEthernet 1/0/2 on Router
A acts as a C-BSR and a C-RP.
To make sure Switch A forwards IPv6 PIM protocol packets and IPv6 multicast data packets only to
routers that are connected to receivers, perform the following tasks:
• On Switch A, configure MLD snooping and IPv6 PIM snooping.
Command
graceful-restart
neighbor-aging-time seconds
ipv6 pim-snooping
graceful-restart join-aging-time
seconds
Figure 74:
Command
display ipv6 pim-snooping neighbor [ vlan vlan-id ] [ slot
slot-number ] [ verbose ]
display ipv6 pim-snooping router-port [ vlan vlan-id ] [ slot
slot-number ] [ verbose ]
display ipv6 pim-snooping routing-table [ vlan vlan-id ] [ slot
slot-number ] [ verbose ]
display ipv6 pim-snooping statistics
reset ipv6 pim-snooping statistics
224
Remarks
seconds.
A global neighbor port is a Layer
2 aggregate interface that acts as
a neighbor port.
The default setting is 210
seconds.
A global downstream port or a
global router port is a Layer 2
aggregate interface that acts as a
downstream port or router port.