HPE FlexNetwork 5510 HI Series Configuration Manual page 86

Figure 31 Network diagram
Multicast router
Switch A
GE1/0/3
Vlan-int100
10.1.1.1/24
Configuration procedure
Assign an IP address and subnet mask for each interface, as shown in
1.
shown.)
Configure OSPF on all the switches. (Details not shown.)
2.
Configure a GRE tunnel:
3.
# On Switch A, create service loopback group 1, and specify the unicast tunnel service for the
group.
<SwitchA> system-view
[SwitchA] service-loopback group 1 type tunnel
# Add GigabitEthernet 1/0/3 to service loopback group 1. (GigabitEthernet 1/0/3 does not
belong to VLAN 100 or VLAN 101.)
[SwitchA] interface gigabitethernet 1/0/3
[SwitchA-GigabitEthernet1/0/3] port service-loopback group 1
[SwitchA-GigabitEthernet1/0/3] quit
# Create a GRE tunnel interface Tunnel 2, and specify the tunnel mode as GRE/IPv4.
[SwitchA] interface tunnel 2 mode gre
# Assign an IP address to interface Tunnel 2, and specify its source and destination addresses.
[SwitchA-Tunnel2] ip address 50.1.1.1 24
[SwitchA-Tunnel2] source 20.1.1.1
[SwitchA-Tunnel2] destination 30.1.1.2
[SwitchA-Tunnel2] quit
# On Switch C, create service loopback group 1, and specify the unicast tunnel service for the
group.
<SwitchC> system-view
[SwitchC] service-loopback group 1 type tunnel
# Add GigabitEthernet 1/0/3 to service loopback group 1. GigabitEthernet 1/0/3 does not belong
to VLAN 200 or VLAN 102.
[SwitchC] interface gigabitethernet 1/0/3
[SwitchC-GigabitEthernet1/0/3] port service-loopback group 1
[SwitchC-GigabitEthernet1/0/3] quit
# Create a GRE tunnel interface Tunnel 2, and specify the tunnel mode as GRE/IPv4.
[SwitchC] interface tunnel 2 mode gre
# Assign an IP address for interface Tunnel 2, and specify its source and destination addresses.
[SwitchC-Tunnel2] ip address 50.1.1.2 24
[SwitchC-Tunnel2] source 30.1.1.2
Vlan-int101
Vlan-int101
20.1.1.1/24
20.1.1.2/24
Tunnel2
50.1.1.1/24
Source
Member port of a service loopback group
10.1.1.100/24
Unicast router
Switch B
Vlan-int102
30.1.1.1/24
GRE tunnel
76
Multicast router
Switch C
Vlan-int102
30.1.1.2/24
GE1/0/3
Vlan-int200
40.1.1.1/24
Tunnel2
50.1.1.2/24
Receiver
40.1.1.100/24
Figure 31. (Details not