Enabling Mld Snooping Proxying; Configuring Parameters For Mld Messages; Configuration Prerequisites; Configuring Source Ipv6 Addresses For Mld Messages - HPE FlexNetwork 5510 HI Series Configuration Manual

Enabling MLD snooping proxying

Before you enable MLD snooping proxying for a VLAN, enable MLD snooping for the VLAN.
To enable MLD snooping proxying:
Step
Enter system view.
1.
Enter VLAN view.
2.
Enable MLD snooping
3.
proxying for the VLAN.

Configuring parameters for MLD messages

This section describes how to configure parameters for MLD messages.

Configuration prerequisites

Before you configure parameters for MLD messages, complete the following tasks:
• Enable MLD snooping for the VLAN.
• Determine the source IPv6 address of MLD general queries.
• Determine the source IPv6 address of MLD multicast-address-specific queries.
• Determine the source IPv6 address of MLD reports.
• Determine the source IPv6 address of MLD done messages.
• Determine the 802.1p priority of MLD messages.

Configuring source IPv6 addresses for MLD messages

You can change the source IPv6 address of the MLD queries sent by an MLD snooping querier. This
configuration might affect MLD querier election within the subnet.
You can also change the source IPv6 address of MLD reports or done messages sent by a simulated
member host or an MLD snooping proxy.
To configure the source IPv6 addresses for MLD messages in a VLAN:
Step
Enter system view.
1.
Enter VLAN view.
2.
Configure the source IPv6
3.
address for MLD general
queries.
Configure the source IPv6
4.
address for MLD
Command
system-view
vlan vlan-id
mld-snooping proxy enable
Command
system-view
vlan vlan-id
mld-snooping general-query
source-ip ipv6-address
mld-snooping special-query
source-ip ipv6-address
204
Remarks
N/A
N/A
By default, MLD snooping
proxying is disabled for a VLAN.
Remarks
N/A
N/A
By default, the source IPv6
address of MLD general queries is
the IPv6 link-local address of the
current VLAN interface. If the
current VLAN interface does not
have an IPv6 link-local address,
the source IPv6 address is
FE80::02FF:FFFF:FE00:0001.
By default, the source IPv6
address of MLD