HPE FlexNetwork 5510 HI Series Configuration Manual page 321

• OSPFv3 runs on the network.
• VOD streams are sent to receiver hosts in multicast. The receivers of different subnets form
stub networks, and a minimum of one receiver host exist in each stub network. The entire IPv6
PIM-SM domain contains only one BSR.
• Host A and Host C are multicast receivers in the stub networks N1 and N2.
• Specify VLAN-interface 102 on Switch E as a C-BSR and a C-RP. The C-RP is designated to
the IPv6 multicast group range FF0E::101/64. Specify VLAN-interface101 of Switch D as the
static RP on all the switches to back up the dynamic RP.
• MLDv1 runs between Switch A and N1, and between Switch B, Switch C, and N2.
Figure 105 Network diagram
Source
4001::100/64
Table 19 Interface and IPv6 address assignment
Device
Switch A
Switch A
Switch A
Switch B
Switch B
Switch C
Switch C
Configuration procedure
Assign an IPv6 address and prefix length to each interface, as shown in
1.
shown.)
Configure OSPFv3 on all switches in the IPv6 PIM-SM domain. (Details not shown.)
2.
Vlan-int300 Vlan-int105
Vlan-int105
Switch D Switch E
IPv6 PIM-SM
Interface IPv6 address
Vlan-int100 1001::1/64
Vlan-int101 1002::1/64
Vlan-int102 1003::1/64
Vlan-int200 2001::1/64
Vlan-int103 2002::1/64
Vlan-int200 2001::2/64
Vlan-int104 3001::1/64
Switch A
Vlan-int100
Vlan-int102
Vlan-int102
Vlan-int103
Vlan-int103
Vlan-int104
Switch B
Vlan-int104
Vlan-int200
Switch C
Device
Switch D
Switch D
Switch D
Switch E
Switch E
Switch E
Switch E
311
Receiver
Host A
Host B
Receiver
Vlan-int200
Host C
Host D
Interface IPv6 address
Vlan-int300 4001::1/64
Vlan-int101 1002::2/64
Vlan-int105 4002::1/64
Vlan-int104 3001::2/64
Vlan-int103 2002::2/64
Vlan-int102 1003::2/64
Vlan-int105 4002::2/64
Figure 105. (Details not