Ipv6 Multicast Group Policy Does Not Work - HPE FlexNetwork 5510 HI Series Configuration Manual

If the problem persists, contact Hewlett Packard Enterprise Support.
4.

IPv6 multicast group policy does not work

Symptom
Hosts can receive IPv6 multicast data for IPv6 multicast groups that are not permitted by the IPv6
multicast group policy.
Solution
To resolve the problem:
Use the display acl ipv6 command to verify that the configured IPv6 ACL meets the IPv6
1.
multicast group policy requirements.
Use the display this command in MLD-snooping view or in interface view to verify that the
2.
correct IPv6 multicast group policy has been applied. If the applied policy is not correct, use the
group-policy or mld-snooping group-policy command to apply the correct IPv6 multicast
group policy.
Use the display mld-snooping command to verify that dropping unknown IPv6 multicast data
3.
is enabled. If it is not, use the drop-unknown or mld-snooping drop-unknown command to
enable dropping unknown IPv6 multicast data.
If the problem persists, contact Hewlett Packard Enterprise Support.
4.
221