Igmp Ssm Mapping Configuration Example - HPE FlexNetwork 5510 HI Series Configuration Manual

Other querier present time for IGMP: 255s
Maximum query response time for IGMP: 10s
Querier for IGMP: 10.110.2.1 (This router)
IGMP groups reported in total: 1

IGMP SSM mapping configuration example

Network requirements
As shown in
• OSPF runs on the network.
• The PIM-SM domain uses both the ASM model and SSM model for multicast delivery.
VLAN-interface 104 on Switch D acts as the C-BSR and C-RP. The SSM group range is
232.1.1.0/24.
• IGMPv3 runs on VLAN-interface 400 of Switch D. The receiver host runs IGMPv2, and does not
support IGMPv3. The receiver host cannot specify multicast sources in its membership reports.
• Source 1, Source 2, and Source 3 send multicast packets to multicast groups in the SSM group
range 232.1.1.0/24.
Configure the IGMP SSM mapping feature on Switch D so that the receiver host can receive
multicast data only from Source 1 and Source 3.
Figure 37 Network diagram
Table 6 Interface and IP address assignment
Device
Source 1
Source 2
Switch A
Switch A
Switch A
Switch B
Switch B
Switch B
Figure 37:
Interface IP address
— 133.133.1.1/24
— 133.133.2.1/24
Vlan-int100 133.133.1.2/24
Vlan-int101 192.168.1.1/24
Vlan-int104 192.168.4.2/24
133.133.2.2/24
Vlan-int200
192.168.1.2/24
Vlan-int101
192.168.2.1/24
Vlan-int102
Device Interface
Source 3 —
Receiver —
Switch C Vlan-int300
Switch C Vlan-int103
Switch C Vlan-int102
Switch D
Vlan-int400
Switch D
Vlan-int103
Switch D
Vlan-int104
95
IP address
133.133.3.1/24
133.133.4.1/24
133.133.3.2/24
192.168.3.1/24
192.168.2.2/24
133.133.4.2/24
192.168.3.2/24
192.168.4.1/24