Configuration Procedure - HPE FlexNetwork 5510 HI Series Configuration Manual

Figure 19 Network diagram
Source 1
1.1.1.100/24
Source 2
2.1.1.100/24

Configuration procedure

Assign an IP address and subnet mask to each interface, as shown in
1.
shown.)
Configure OSPF on the routers. (Details not shown.)
2.
Configure Router A:
3.
# Enable IP multicast routing.
<RouterA> system-view
[RouterA] multicast routing
[RouterA-mrib] quit
# Enable PIM-SM on each interface.
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] pim sm
[RouterA-GigabitEthernet1/0/1] quit
[RouterA] interface gigabitethernet 1/0/2
[RouterA-GigabitEthernet1/0/2] pim sm
[RouterA-GigabitEthernet1/0/2] quit
# Set the maximum size of a join or prune message to 1400 bytes.
[RouterA] pim
[RouterA-pim] jp-pkt-size 1400
# Configure GigabitEthernet 1/0/2 as a C-BSR and a C-RP.
[RouterA-pim] c-bsr 10.1.1.1
[RouterA-pim] c-rp 10.1.1.1
[RouterA-pim] quit
Configure Router B:
4.
# Enable IP multicast routing.
<RouterB> system-view
[RouterB] multicast routing
[RouterB-mrib] quit
# Enable PIM-SM on each interface.
[RouterB] interface gigabitethernet 1/0/1
Router A
GE1/0/1 GE1/0/2
1.1.1.1/24 10.1.1.1/24
GE1/0/1
GE1/0/2
GE1/0/1 GE1/0/2
2.1.1.1/24 10.1.1.2/24
Router B
Router C
GE1/0/2
10.1.1.3/24
Switch A
GE1/0/3
GE1/0/4
GE1/0/2
10.1.1.4/24
Router D
47
Receiver 1
GE1/0/1
3.1.1.1/24
3.1.1.100/24
Receiver 2
GE1/0/1
4.1.1.1/24
4.1.1.100/24
Figure 19. (Details not