Pim-Sm Admin-Scoped Zone Configuration Example - HPE FlexNetwork 5510 HI Series Configuration Manual

Scope: non-scoped
State: Accept Preferred
Bootstrap timer: 00:01:44
Elected BSR address: 192.168.9.2
Priority: 64
Hash mask length: 30
Uptime: 00:11:18
# Display BSR information on Switch E.
[SwitchE] display pim bsr-info
Scope: non-scoped
State: Elected
Bootstrap timer: 00:01:44
Elected BSR address: 192.168.9.2
Priority: 64
Hash mask length: 30
Uptime: 00:11:18
Candidate BSR address: 192.168.9.2
Priority: 64
Hash mask length: 30
# Display RP information on Switch A.
[SwitchA] display pim rp-info
BSR RP information:
Scope: non-scoped
Group/MaskLen: 225.1.1.0/24
RP address
192.168.9.2
Static RP information:
RP address
192.168.1.2

PIM-SM admin-scoped zone configuration example

Network requirements
As shown in
• OSPF runs on the network.
• VOD streams are sent to receiver hosts in multicast. The entire PIM-SM domain is divided into
admin-scoped zone 1, admin-scoped zone 2, and the global-scoped zone. Switch B, Switch C,
and Switch D are ZBRs of the three zones, respectively.
• Source 1 and Source 2 send different multicast data to the multicast group 239.1.1.1. Host A
receives the multicast data only from Source 1, and Host B receives the multicast data only
from Source 2. Source 3 sends multicast data to multicast group 224.1.1.1. Host C is a
multicast receiver for the multicast group 224.1.1.1.
• VLAN-interface 101 of Switch B acts as a C-BSR and a C-RP for admin-scoped zone 1, and
VLAN-interface 105 of Switch D acts as a C-BSR and a C-RP for admin-scoped zone 2. Both of
the two interfaces are designated to multicast group range 239.0.0.0/8. VLAN-interface 109 of
Switch F acts as a C-BSR and a C-RP for the global-scoped zone, and is designated to all the
multicast groups that are not in the range 239.0.0.0/8.
Figure 55:
Priority HoldTime
192 180
ACL Mode Preferred
---- pim-sm No
144
Uptime Expires
00:51:45 00:02:22