Configuring Common Ipv6 Pim Features; Configuration Task List; Configuration Prerequisites; Configuring An Ipv6 Multicast Source Policy - HPE FlexNetwork 5510 HI Series Configuration Manual

Step
Enter system view.
1.
Enter IPv6 PIM view.
2.
Configure the IPv6 SSM
3.
group range.

Configuring common IPv6 PIM features

Configuration task list

Tasks at a glance
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)

Configuration prerequisites

Before you configure common IPv6 PIM features, complete the following tasks:
• Configure an IPv6 unicast routing protocol so that all devices in the domain can interoperate at
the network layer.
• Configure IPv6 PIM-DM or IPv6 PIM-SSM.

Configuring an IPv6 multicast source policy

This feature enables the device to filter IPv6 multicast data by using an ACL that specifies the IPv6
multicast sources and the optional groups. It filters not only IPv6 multicast data packets but also IPv6
PIM register messages with IPv6 multicast data encapsulated. This also reduces the IPv6 multicast
traffic on the network.
To configure an IPv6 multicast source policy:
Step
Enter system view.
1.
Enter IPv6 PIM view.
2.
Configure an IPv6 multicast
3.
source policy.
Configuring an IPv6 multicast source policy
Configuring an IPv6 PIM hello policy
Configuring IPv6 PIM hello message options
Configuring common IPv6 PIM timers
Setting the maximum size of a join or prune message
Enabling BFD for IPv6 PIM
Enabling IPv6 PIM passive mode
Enabling IPv6 PIM NSR
Enabling SNMP notifications for IPv6 PIM
Command
system-view
ipv6 pim
ssm-policy ipv6-acl-number
Command
system-view
ipv6 pim [ vpn-instance
vpn-instance-name ]
source-policy ipv6-acl-number
301
Remarks
N/A
N/A
The default range is FF3x::/32,
where x can be any valid scope.
Remarks
N/A
N/A
By default, no IPv6 multicast
source policy exists. The device
does not filter IPv6 multicast data