Igmp Snooping Configuration Examples; Group Policy And Simulated Joining Configuration Example - HPE FlexNetwork 5510 HI Series Configuration Manual

IGMP snooping configuration examples

Group policy and simulated joining configuration example

Network requirements
As shown in
snooping.
Configure a multicast group policy and simulated joining to meet the following requirements:
• Host A and Host B receive only the multicast data addressed to multicast group 224.1.1.1.
Multicast data can be forwarded through GigabitEthernet 1/0/3 and GigabitEthernet 1/0/4 of
Switch A uninterruptedly, even though Host A and Host B fail to receive the multicast data.
• Switch A will drop unknown multicast data instead of flooding it in VLAN 100.
Figure 14 Network diagram
Source
1.1.1.2/24
1.1.1.1/24
Configuration procedure
Assign an IP address and subnet mask to each interface, as shown in
1.
shown.)
Configure Router A:
2.
# Enable IP multicast routing.
<RouterA> system-view
[RouterA] multicast routing
[RouterA-mrib] quit
# Enable IGMP on GigabitEthernet 1/0/1.
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] igmp enable
[RouterA-GigabitEthernet1/0/1] quit
# Enable PIM-DM on GigabitEthernet 1/0/2.
[RouterA] interface gigabitethernet 1/0/2
[RouterA-GigabitEthernet1/0/2] pim dm
[RouterA-GigabitEthernet1/0/2] quit
Figure 14, Router A runs IGMPv2 and acts as the IGMP querier. Switch A runs IGMPv2
GE1/0/2 GE1/0/1
10.1.1.1/24
Router A
IGMP querier
Receiver
Host A
GE1/0/4
GE1/0/1 GE1/0/3
Switch A
GE1/0/2
Host C
34
Receiver
Host B
VLAN 100
Figure 14. (Details not