HPE FlexNetwork 5510 HI Series Configuration Manual page 195

Figure 65 Network diagram
PIM-SM 1
Receiver
Host A
Source 1
Table 15 Interface and IP address assignment
Device
Source 1
Source 2
Switch A
Switch A
Switch A
Switch A
Switch B
Switch B
Switch B
Configuration procedure
Assign an IP address and subnet mask to each interface, as shown in
1.
shown.)
Configure OSPF on the switches in the PIM-SM domains. (Details not shown.)
2.
Enable IP multicast routing, IGMP, and PIM-SM, and configure PIM domain borders:
3.
# On Switch A, enable IP multicast routing.
<SwitchA> system-view
[SwitchA] multicast routing
[SwitchA-mrib] quit
# Enable IGMP on the receiver-side interface (VLAN-interface 100).
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] igmp enable
[SwitchA-Vlan-interface100] quit
# Enable PIM-SM on the other interfaces.
Loop0
Vlan-int100
Switch A
Vlan-int200
Switch B
MSDP peers
Interface IP address
— 10.110.3.100/24
— 10.110.6.100/24
Vlan-int100 10.110.1.1/24
Vlan-int102 10.110.2.1/24
Vlan-int101 192.168.1.1/24
Loop0 1.1.1.1/32
Vlan-int200 10.110.3.1/24
Vlan-int102 10.110.2.2/24
Vlan-int103 192.168.2.1/24
PIM-SM 2
Loop0
Switch C
Vlan-int104
Vlan-int300
Receiver
Host B
Device
Switch C
Switch C
Switch C
Switch C
Switch C
Switch D
Switch D
Switch D
Switch D
185
PIM-SM 3
Source 2
Vlan-int400
Vlan-int104
Switch D
Vlan-int500
Receiver
Host C
Interface IP address
Vlan-int300 10.110.4.1/24
Vlan-int104 10.110.5.1/24
Vlan-int101 192.168.1.2/24
Vlan-int103 192.168.2.2/24
Loop0 2.2.2.2/32
Vlan-int400 10.110.6.1/24
Vlan-int500 10.110.7.1/24
Vlan-int104 10.110.5.2/24
Loop0 3.3.3.3/32
Figure 65. (Details not