HPE FlexNetwork 5510 HI Series Configuration Manual page 20

Ip multicast
Hide thumbs Also See for FlexNetwork 5510 HI Series:
Table of Contents

Advertisement

An inter-domain multicast routing protocol is used for delivering multicast information
between two ASs. So far, mature solutions include Multicast Source Discovery Protocol
(MSDP) and MBGP. MSDP propagates multicast source information among different ASs.
MBGP is an extension of the MP-BGP for exchanging multicast routing information among
different ASs.
For the SSM model, multicast routes are not divided into intra-domain routes and inter-domain
routes. Because receivers know the positions of the multicast sources, channels established
through PIM-SM are sufficient for the transport of multicast information.
Layer 2 multicast protocols
In
Figure
9, Layer 2 multicast protocols include IGMP snooping, MLD snooping, PIM snooping, IPv6
PIM snooping, multicast VLAN, and IPv6 multicast VLAN.
Figure 9 Positions of Layer 2 multicast protocols
Source 1
/IPv6 PIM Snooping
Source 2
IPv4/IPv6 multicast packets (S1, G1)
IGMP snooping and MLD snooping:
IGMP snooping and MLD snooping are multicast constraining mechanisms that run on Layer 2
devices. They manage and control multicast groups by monitoring and analyzing IGMP or MLD
messages exchanged between the hosts and Layer 3 multicast devices. This effectively
controls the flooding of multicast data in Layer 2 networks.
PIM snooping and IPv6 PIM snooping:
PIM snooping and IPv6 PIM snooping run on Layer 2 devices. They work with IGMP snooping
or MLD snooping to analyze received PIM messages. Then, they add the ports that are
interested in specific multicast data to a PIM snooping routing entry or IPv6 PIM snooping
routing entry. In this way, multicast data can be forwarded to only the ports that are interested in
the data.
Multicast VLAN and IPv6 multicast VLAN:
Multicast VLAN or IPv6 multicast VLAN runs on a Layer 2 device in a multicast network where
multicast receivers for the same group exist in different VLANs. With these protocols, the Layer
3 multicast device sends only one copy of multicast to the multicast VLAN or IPv6 multicast
VLAN on the Layer 2 device. This method avoids waste of network bandwidth and extra burden
on the Layer 3 device.
PIM Snooping
Multicast VLAN
/IPv6 Multicast VLAN
Receiver
IPv4/IPv6 multicast packets (S2, G2)
10
IGMP Snooping
/MLD Snooping
Receiver
Receiver

Advertisement

Table of Contents
loading

Table of Contents