Ipv6 Static Routing Configuration Example - HPE 5800 Series Configuration Manual

Task
Display IPv6 static route
information.

IPv6 static routing configuration example

Network requirements
As shown in
Figure 81 Network diagram
Configuration procedure
Configure the IPv6 addresses for all VLAN interfaces. (Details not shown.)
1.
Configure IPv6 static routes:
2.
# Enable IPv6 and configure an IPv6 static route on Switch A.
<SwitchA> system-view
[SwitchA] ipv6
[SwitchA] ipv6 route-static :: 0 4::2
# Enable IPv6 and configure two IPv6 static routes on Switch B.
<SwitchB> system-view
[SwitchB] ipv6
[SwitchB] ipv6 route-static 1:: 64 4::1
[SwitchB] ipv6 route-static 3:: 64 5::1
# Enable IPv6 and configure an IPv6 static route on Switch C.
<SwitchC> system-view
[SwitchC] ipv6
[SwitchC] ipv6 route-static :: 0 5::2
Configure the IPv6 addresses for all hosts based on the network diagram, and configure the
3.
default gateway of Host A, Host B, and Host C as 1::1, 2::1, and 3::1.
Verify the configuration:
4.
# Display the IPv6 routing table on Switch A.
[SwitchA] display ipv6 routing-table
Routing Table : Public
Command
display ipv6 routing-table
protocol static [ inactive |
verbose ] [ | { begin | exclude |
include } regular-expression ]
Figure 81, configure IPv6 static routes so that hosts can reach one another.
248
Remarks
Available in any view.