Anycast Rp Configuration - HPE FlexNetwork 5510 HI Series Configuration Manual

[SwitchD] ip prefix-list list-a permit 10.110.0.0 16 greater-equal 16 less-equal 32
[SwitchD] msdp
[SwitchD-msdp] peer 10.110.1.1 connect-interface vlan-interface 103
[SwitchD-msdp] static-rpf-peer 10.110.1.1 rp-policy list-a
[SwitchD-msdp] quit
# On Switch G, configure Switch A as the MSDP peer and static RPF peer.
[SwitchG] ip prefix-list list-a permit 10.110.0.0 16 greater-equal 16 less-equal 32
[SwitchG] msdp
[SwitchG-msdp] peer 10.110.2.1 connect-interface vlan-interface 106
[SwitchG-msdp] static-rpf-peer 10.110.2.1 rp-policy list-a
[SwitchG-msdp] quit
Verifying the configuration
# Display the BGP peering relationships on Switch A.
[SwitchA] display bgp peer
No information is output, because no BGP peering relationship has been established between
Switch A and Switch D, or between Switch A and Switch G. This means that the unicast topology is
not changed.
# Display brief information about MSDP peers on Switch A.
[SwitchA] display msdp brief
Configured
2
Peer address
10.110.3.2
10.110.6.2
# Display brief information about MSDP peers on Switch D.
[SwitchD] display msdp brief
Configured
1
Peer address
10.110.1.1
# Display brief information about MSDP peers on Switch G.
[SwitchG] display msdp brief
Configured
1
Peer address
10.110.2.1
# Verify that receivers in PIM-SM 1 and PIM-SM 3 can receive the multicast data from Source 1 and
Source 2 to a multicast group. (Details not shown.)

Anycast RP configuration

Network requirements
As shown in
Established Listen
2 0
State Up/Down time
Established 01:07:08
Established 00:16:39
Established Listen
1 0
State Up/Down time
Established 01:07:09
Established Listen
1 0
State Up/Down time
Established 00:16:40
Figure 64, OSPF runs within the domain to provide unicast routes.
Connect Shutdown
0 0
AS SA count
? 8
? 13
Connect Shutdown
0 0
AS SA count
? 8
Connect Shutdown
0 0
AS SA count
? 13
180
Disabled
0
Reset count
0
0
Disabled
0
Reset count
0
Disabled
0
Reset count
0