HPE FlexNetwork 5510 HI Series Configuration Manual page 229

Figure 72 Network diagram
Source
GE1/0/2
1::1/64
Configuration procedure
Assign an IPv6 address and subnet mask to each interface, as shown in
1.
shown.)
Configure Router A:
2.
# Enable IPv6 multicast routing.
<RouterA> system-view
[RouterA] ipv6 multicast routing
[RouterA-mrib6] quit
# Enable MLD and IPv6 PIM-DM on GigabitEthernet 1/0/1.
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] mld enable
[RouterA-GigabitEthernet1/0/1] ipv6 pim dm
[RouterA-GigabitEthernet1/0/1] quit
# Enable IPv6 PIM-DM on GigabitEthernet 1/0/2.
[RouterA] interface gigabitethernet 1/0/2
[RouterA-GigabitEthernet1/0/2] ipv6 pim dm
[RouterA-GigabitEthernet1/0/2] quit
Configure Switch A:
3.
# Enable the MLD snooping feature.
<SwitchA> system-view
[SwitchA] mld-snooping
[SwitchA-mld-snooping] quit
# Create VLAN 100, and assign GigabitEthernet 1/0/1 through GigabitEthernet 1/0/4 to the
VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port gigabitethernet 1/0/1 to gigabitethernet 1/0/4
# Enable MLD snooping and MLD snooping proxying for the VLAN.
[SwitchA-vlan100] mld-snooping enable
[SwitchA-vlan100] mld-snooping proxy enable
[SwitchA-vlan100] quit
GE1/0/1
1::2/64 2001::1/64
Router A
MLD querier
Receiver
Host A
GE1/0/4
GE1/0/1 GE1/0/3
Switch A
GE1/0/2
Proxy
Host C
219
Receiver
Host B
VLAN 100
Figure 72. (Details not