HPE FlexNetwork 5510 HI Series Configuration Manual page 183

Ip multicast
Hide thumbs Also See for FlexNetwork 5510 HI Series:
Table of Contents

Advertisement

Switch C
Configuration procedure
Assign an IP address and subnet mask to each interface, as shown in
1.
shown.)
Configure OSPF on the switches in the ASs. (Details not shown.)
2.
Enable IP multicast routing and PIM-SM, and configure PIM-SM domain borders:
3.
# On Switch A, enable IP multicast routing.
<SwitchA> system-view
[SwitchA] multicast routing
[SwitchA-mrib] quit
# Enable PIM-SM on VLAN-interface 103 and VLAN-interface 100.
[SwitchA] interface vlan-interface 103
[SwitchA-Vlan-interface103] pim sm
[SwitchA-Vlan-interface103] quit
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] pim sm
[SwitchA-Vlan-interface100] quit
# Enable IGMP on the receiver-side interface (VLAN-interface 200).
[SwitchA] interface vlan-interface 200
[SwitchA-Vlan-interface200] igmp enable
[SwitchA-Vlan-interface200] quit
# Enable IP multicast routing and PIM-SM on Switch B, Switch C, Switch D, Switch E, and
Switch F in the same way Switch A is configured. (Details not shown.)
# Configure a PIM domain border on Switch B.
[SwitchB] interface vlan-interface 101
[SwitchB-Vlan-interface101] pim bsr-boundary
[SwitchB-Vlan-interface101] quit
# Configure a PIM domain border on Switch C and Switch E in the same way Switch B is
configured. (Details not shown.)
Configure C-BSRs and C-RPs:
4.
# Configure Loopback 0 as a C-BSR and a C-RP on Switch B.
[SwitchB] pim
[SwitchB-pim] c-bsr 1.1.1.1
[SwitchB-pim] c-rp 1.1.1.1
[SwitchB-pim] quit
# Configure C-BSRs and C-RPs on Switch C and Switch E in the same way Switch B is
configured. (Details not shown.)
Configure BGP for mutual route redistribution between BGP and OSPF:
5.
# On Switch B, configure an EBGP peer, and redistribute OSPF routes.
[SwitchB] bgp 100
[SwitchB-bgp] router-id 1.1.1.1
[SwitchB-bgp] peer 192.168.1.2 as-number 200
[SwitchB-bgp] address-family ipv4 unicast
[SwitchB-bgp-ipv4] import-route ospf 1
[SwitchB-bgp-ipv4] peer 192.168.1.2 enable
[SwitchB-bgp-ipv4] quit
Loop0
2.2.2.2/32
Switch D
Vlan-int104
173
10.110.4.2/24
Figure
62. (Details not

Advertisement

Table of Contents
loading

Table of Contents