HPE FlexNetwork 5510 HI Series Configuration Manual page 318

• Host A and Host C are multicast receivers in two stub networks N1 and N2.
• MLDv1 runs between Switch A and N1, and between Switch B, Switch C, and N2.
Figure 104 Network diagram
Source
4001::100/64
Table 18 Interface and IPv6 address assignment
Device
Switch A
Switch A
Switch B
Switch B
Switch C
Switch C
Configuration procedure
Assign an IPv6 address and prefix length to each interface, as shown in
1.
shown.)
Configure OSPFv3 on the switches in the IPv6 PIM-DM domain. (Details not shown.)
2.
Enable IPv6 multicast routing, MLD, and IPv6 PIM-DM:
3.
# On Switch A, enable IPv6 multicast routing.
<SwitchA> system-view
[SwitchA] ipv6 multicast routing
[SwitchA-mrib6] quit
# Enable MLD on VLAN-interface 100 (the interface that is connected to the stub network).
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] mld enable
[SwitchA-Vlan-interface100] quit
Vlan-int300 Vlan-int101
Switch D
IPv6 PIM-DM
Interface IPv6 address
Vlan-int100 1001::1/64
Vlan-int103 1002::1/64
Vlan-int200 2001::1/64
Vlan-int101 2002::1/64
Vlan-int200 2001::2/64
Vlan-int102 3001::1/64
Switch A
Vlan-int100
Vlan-int200
Vlan-int101
Switch B
Vlan-int200
Switch C
Device
Switch D
Switch D
Switch D
Switch D
Switch D
Switch D
308
Receiver
Host A
Host B
Receiver
Host C
Host D
Interface IPv6 address
Vlan-int300 4001::1/64
Vlan-int103 1002::2/64
Vlan-int101 2002::2/64
Vlan-int102 3001::2/64
Vlan-int300 4001::1/64
Vlan-int103 1002::2/64
Figure 104. (Details not