HPE FlexNetwork 5510 HI Series Configuration Manual page 152

• VOD streams are sent to receiver hosts in multicast. The receivers of different subnets form
stub networks, and a minimum of one receiver host exist on each stub network.
• The entire PIM-SM domain contains only one BSR.
• Host A and Host C are multicast receivers on two stub networks N1 and N2.
• Specify VLAN-interface 102 on Switch E as a C-BSR and a C-RP. The C-RP is designated to
multicast group range 225.1.1.0/24. Specify VLAN-interface 101 of Switch D as the static RP on
all the switches to back up the dynamic RP.
• IGMPv2 runs between Switch A and N1, and between Switch B, Switch C, and N2.
Figure 54 Network diagram
Source
10.110.5.100/24
Table 8 Interface and IP address assignment
Device
Switch A
Switch A
Switch A
Switch B
Switch B
Switch C
Switch C
Configuration procedure
Assign an IP address and subnet mask to each interface, as shown in
1.
shown.)
Configure OSPF on all switches in the PIM-SM domain. (Details not shown.)
2.
Vlan-int300 Vlan-int105
Vlan-int105
Switch D Switch E
PIM-SM
Interface IP address
Vlan-int100 10.110.1.1/24
Vlan-int101 192.168.1.1/24
Vlan-int102 192.168.9.1/24
Vlan-int200 10.110.2.1/24
Vlan-int103 192.168.2.1/24
Vlan-int200 10.110.2.2/24
Vlan-int104 192.168.3.1/24
Switch A
Vlan-int100
Vlan-int102
Vlan-int102
Vlan-int103
Vlan-int103
Vlan-int104
Switch B
Vlan-int104
Vlan-int200
Switch C
Device
Switch D
Switch D
Switch D
Switch E
Switch E
Switch E
Switch E
142
Receiver
Host A
Host B
Receiver
Vlan-int200
Host C
Host D
Interface IP address
Vlan-int300 10.110.5.1/24
Vlan-int101 192.168.1.2/24
Vlan-int105 192.168.4.2/24
Vlan-int104 192.168.3.2/24
Vlan-int103 192.168.2.2/24
Vlan-int102 192.168.9.2/24
Vlan-int105 192.168.4.1/24
Figure 54. (Details not