HPE FlexNetwork 5510 HI Series Configuration Manual page 278

• IPv6 PIM-DM runs on the core network.
• Host A and Host C on the stub network receive VOD information destined to IPv6 multicast
group FF3E::101.
Configure the MLD proxying feature on Switch B so that Switch B can maintain group memberships
and forward IPv6 multicast traffic without running IPv6 PIM-DM.
Figure 89 Network diagram
Proxy & Querier
Switch B
Vlan-int200
3001::1/64
Receiver
Host A
Configuration procedure
Assign an IPv6 address and prefix length to each interface, as shown in
1.
shown.)
Enable IPv6 multicast routing, IPv6 PIM-DM, MLD, and MLD proxying:
2.
# On Switch A, enable IPv6 multicast routing.
<SwitchA> system-view
[SwitchA] ipv6 multicast routing
[SwitchA-mrib6] quit
# Enable IPv6 PIM-DM on VLAN-interface 101.
[SwitchA] interface vlan-interface 101
[SwitchA-Vlan-interface101] ipv6 pim dm
[SwitchA-Vlan-interface101] quit
# Enable MLD on VLAN-interface 100.
[SwitchA] interface vlan-interface 100
[SwitchA-Vlan-interface100] mld enable
[SwitchA-Vlan-interface100] quit
# On Switch B, enable IPv6 multicast routing.
<SwitchB> system-view
[SwitchB] multicast ipv6 routing-enable
[SwitchB-mrib6] quit
# Enable MLD proxying on VLAN-interface 100.
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] mld proxying enable
[SwitchB-Vlan-interface100] quit
# Enable MLD on VLAN-interface 200.
[SwitchB] interface vlan-interface 200
[SwitchB-Vlan-interface200] mld enable
Querier
Switch A
Vlan-int100
2001::1/64
Vlan-int100
2001::2/64
Host B
IPv6 PIM-DM
Vlan-int101
1001::1/64
Receiver
Host C
268
Figure 89. (Details not