Configuring Multicast Load Splitting; Configuring A Multicast Forwarding Boundary; Enabling Multicast Forwarding Between Sub-Vlans Of A Super Vlan - HPE FlexNetwork 5510 HI Series Configuration Manual

Configuring multicast load splitting

You can enable the device to split multiple data flows on a per-source basis or on a
per-source-and-group basis. This optimizes the traffic delivery.
To configure multicast load splitting:
Step
Enter system view.
1.
Enter MRIB view.
2.
Configure multicast load
3.
splitting.

Configuring a multicast forwarding boundary

You can configure an interface as a multicast forwarding boundary for a multicast group range. The
interface cannot receive or forward multicast packets for the group range.
TIP:
You do not need to enable IP multicast routing before this configuration.
To configure a multicast forwarding boundary:
Step
Enter system view.
1.
Enter interface view.
2.
Configure the interface as a
3.
multicast forwarding
boundary for a multicast
group range.
Enabling multicast forwarding between
sub-VLANs of a super VLAN
A super VLAN is associated with multiple sub-VLANs. Sub-VLANs are isolated with each other at
Layer 2. For information about the super VLAN and sub-VLANs, see Layer 2—LAN Switching
Configuration Guide.
To enable multicast forwarding between sub-VLANs that are associated with a super VLAN:
Step
Enter system view.
1.
Enter VLAN interface view.
2.
Command
system-view
multicast routing [ vpn-instance
vpn-instance-name ]
load-splitting { source |
source-group }
Command
system-view
interface interface-type
interface-number
multicast boundary
group-address { mask-length |
mask }
Command
system-view
interface vlan-interface
interface-number
69
Remarks
N/A
N/A
By default, multicast load splitting
is disabled.
This command does not take
effect on BIDIR-PIM.
Remarks
N/A
N/A
By default, an interface is not a
multicast forwarding boundary.
Remarks
N/A
N/A