Configuring The Switchover To Spt; Configuring Ipv6 Bidir-Pim; Ipv6 Bidir-Pim Configuration Task List - HPE FlexNetwork 5510 HI Series Configuration Manual

Step
register policy.
Configure the device to
4.
calculate the checksum
based on the entire register
message.
Configure the register
5.
suppression time.

Configuring the switchover to SPT

CAUTION:
If the router is an RP, disabling the switchover to SPT might cause multicast traffic forwarding
failures on the source-side DR. When disabling switchover to SPT, make sure you fully understand
its impact on your network.
To configure the switchover to SPT:
Step
Enter system view.
1.
Enter IPv6 PIM view.
2.
Configure the switchover to
3.
SPT.

Configuring IPv6 BIDIR-PIM

This section describes how to configure IPv6 BIDIR-PIM.

IPv6 BIDIR-PIM configuration task list

Tasks at a glance
(Required.)
(Required.)
• Configuring a static RP
• Configuring a C-RP
• Setting the maximum number of IPv6 BIDIR-PIM RPs
Configuring a BSR
• (Required.)
• (Optional.)
• (Optional.)
• (Optional.)
BSMs out of their incoming interfaces
(Optional.)
Enabling IPv6 BIDIR-PIM
Configuring an RP:
Configuring a C-BSR
Configuring an IPv6 PIM domain border
Disabling BSM semantic fragmentation
Disabling the device from forwarding
Configuring common IPv6 PIM features
Command
register-whole-checksum
register-suppression-timeout
interval
Command
system-view
ipv6 pim [ vpn-instance
vpn-instance-name ]
spt-switch-threshold
{ immediacy | infinity }
[ group-policy ipv6-acl-number ]
294
Remarks
exists, and all IPv6 register
messages are regarded as legal.
By default, the device calculates
the checksum based on the
header of a register message.
The default setting is 60 seconds.
Remarks
N/A
N/A
By default, the first IPv6 multicast
data packet triggers the RPT to
SPT switchover.
Remarks
N/A
You must configure a static RP, a C-RP, or
both in an IPv6 BIDIR-PIM domain.
Skip the task of configuring a BSR on an IPv6
network without C-RPs.
N/A