Troubleshooting Ipv6 Pim Snooping; Ipv6 Pim Snooping Does Not Work On A Layer 2 Device - HPE FlexNetwork 5510 HI Series Configuration Manual

GE1/0/4
The output shows the following information:
• Switch A will forward the multicast data intended for IPv6 multicast group FF1E::101 to only
Router C.
• Switch A will forward the multicast data intended for IPv6 multicast group FF2E::101 to only
Router D.

Troubleshooting IPv6 PIM snooping

This section describes common IPv6 PIM snooping problems and how to troubleshoot them.

IPv6 PIM snooping does not work on a Layer 2 device

Symptom
IPv6 PIM snooping does not work on a Layer 2 device.
Solution
To resolve the problem:
Use the display current-configuration command to display information about MLD snooping
1.
and IPv6 PIM snooping.
If MLD snooping is not enabled, enable the MLD snooping feature, and then enable MLD
2.
snooping and IPv6 PIM snooping for the VLAN.
If IPv6 PIM snooping is not enabled, enable IPv6 PIM snooping for the VLAN.
3.
If the problem persists, contact Hewlett Packard Enterprise Support.
4.
Expires: 00:03:01, FSM: J
228