HPE FlexNetwork 5510 HI Series Configuration Manual page 259

On Switch C, configure a static IPv6 route with the destination address 1001::1/64 and the
5.
outgoing interface Tunnel 2.
[SwitchC] ipv6 route-static 1001::1 64 tunnel 2
Verifying the configuration
# Send an MLD report from Receiver to join the IPv6 multicast group FF1E::101. (Details not shown.)
# Send IPv6 multicast data from Source to the IPv6 multicast group FF1E::101. (Details not shown.)
# Display IPv6 PIM routing entries on Switch C.
[SwitchC] display ipv6 pim routing-table
Total 1 (*, G) entry; 1 (S, G) entry
(*, FF1E::101)
Protocol: pim-dm, Flag: WC
UpTime: 00:04:25
Upstream interface: NULL
Upstream neighbor: NULL
RPF prime neighbor: NULL
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlan-interface200
(1001::100, FF1E::101)
Protocol: pim-dm, Flag: ACT
UpTime: 00:06:14
Upstream interface: Tunnel2
Upstream neighbor: FE80::A01:101:1
RPF prime neighbor: FE80::A01:101:1
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlan-interface200
The output shows the following information:
• Switch A is the RPF neighbor of Switch C.
• IPv6 multicast data from Switch A is delivered over the GRE tunnel to Switch C.
Protocol: mld, UpTime: 00:04:25, Expires: -
Protocol: pim-dm, UpTime: 00:04:25, Expires: -
249