Enabling Ipv6 Multicast Forwarding Between Sub-Vlans Of A Super Vlan; Displaying And Maintaining Ipv6 Multicast Routing And Forwarding - HPE FlexNetwork 5510 HI Series Configuration Manual

To configure an IPv6 multicast forwarding boundary:
Step
Enter system view.
1.
Enter interface view.
2.
Configure an IPv6 multicast
3.
forwarding boundary.
Enabling IPv6 multicast forwarding between sub-VLANs of a
super VLAN
A super VLAN is associated with multiple sub-VLANs. Sub-VLANs are isolated with each other at
Layer 2. For information about the super VLAN and sub-VLANs, see Layer 2—LAN Switching
Configuration Guide.
To enable IPv6 multicast forwarding between sub-VLANs that are associated with a super VLAN:
Step
Enter system view.
1.
Enter VLAN interface view.
2.
Enable IPv6 multicast
3.
forwarding between
sub-VLANs that are
associated with a super
VLAN.
Delete all IPv6 multicast
4.
forwarding entries with super
VLAN interface as the
incoming interface.
Displaying and maintaining IPv6 multicast routing
and forwarding
CAUTION:
The reset commands might cause IPv6 multicast data transmission failures.
Execute display commands in any view and reset commands in user view.
Command
system-view
interface interface-type
interface-number
ipv6 multicast boundary
{ ipv6-group-address prefix-length
| scope { scope-id | admin-local |
global | organization-local |
site-local } }
Command
system-view
interface vlan-interface
interface-number
ipv6 multicast forwarding
supervlan community
reset ipv6 multicast
[ vpn-instance
vpn-instance-name ]
forwarding-table
{ { ipv6-source-address
[ prefix-length ] |
ipv6-group-address
[ prefix-length ] |
incoming-interface
{ interface-type
interface-number } } * | all }
245
Remarks
N/A
N/A
By default, an interface is not an
IPv6 multicast forwarding
boundary for any IPv6 multicast
groups.
Remarks
N/A
N/A
By default, IPv6 multicast data
cannot be forwarded among
sub-VLANs that are associated
with a super VLAN.
N/A