Configuring Common Pim Features; Configuration Task List; Configuration Prerequisites; Configuring A Multicast Source Policy - HPE FlexNetwork 5510 HI Series Configuration Manual

Configuration procedure
To configure an SSM group range:
Step
Enter system view.
1.
Enter PIM view.
2.
Configure the SSM group
3.
range.

Configuring common PIM features

Configuration task list

Tasks at a glance
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)

Configuration prerequisites

Before you configure common PIM features, complete the following tasks:
• Configure a unicast routing protocol so that all devices in the domain can interoperate at the
network layer.
• Configure PIM-DM or PIM-SM.

Configuring a multicast source policy

This feature enables the device to filter multicast data by using an ACL that specifies the multicast
sources and the optional groups. It filters not only data packets but also register messages with
multicast data encapsulated. It controls the information available to downstream receivers.
To configure a multicast source policy:
Step
Enter system view.
1.
Enter PIM view.
2.
Configuring a multicast source policy
Configuring a PIM hello policy
Configuring PIM hello message options
Configuring common PIM timers
Setting the maximum size of a join or prune message
Enabling BFD for PIM
Enabling PIM passive mode
Enabling PIM NSR
Enabling SNMP notifications for PIM
Setting a DSCP value for outgoing PIM messages
Command
system-view
pim
ssm-policy ipv4-acl-number
Command
system-view
pim [ vpn-instance
132
Remarks
N/A
N/A
By default, the SSM group range
is 232.0.0.0/8.
Remarks
N/A
N/A