Igmp Snooping Proxying Configuration Example - HPE FlexNetwork 5510 HI Series Configuration Manual

Received error IGMP messages:
The output shows that all switches except Switch A can receive the IGMP general queries after
Switch A acts as the IGMP snooping querier.

IGMP snooping proxying configuration example

Network requirements
As shown in
snooping. Configure IGMP snooping proxying so that Switch A can perform the following actions:
• Forward IGMP report and leave messages to Router A.
• Respond to IGMP queries sent by Router A and forward the queries to downstream hosts.
Figure 17 Network diagram
Source
1.1.1.2/24
1.1.1.1/24
Configuration procedure
Assign an IP address and subnet mask to each interface, as shown in
1.
shown.)
Configure Router A:
2.
# Enable IP multicast routing.
<RouterA> system-view
[RouterA] multicast routing
[RouterA-mrib] quit
# Enable IGMP and PIM-DM on GigabitEthernet 1/0/1.
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] igmp enable
[RouterA-GigabitEthernet1/0/1] pim dm
[RouterA-GigabitEthernet1/0/1] quit
# Enable PIM-DM on GigabitEthernet 1/0/2.
[RouterA] interface gigabitethernet 1/0/2
[RouterA-GigabitEthernet1/0/2] pim dm
[RouterA-GigabitEthernet1/0/2] quit
Configure Switch A:
3.
Figure 17, Router A runs IGMPv2 and acts as the IGMP querier. Switch A runs IGMPv2
GE1/0/2 GE1/0/1
10.1.1.1/24
Router A
IGMP querier
0
Receiver
Host A
GE1/0/4
GE1/0/1 GE1/0/3
Switch A
GE1/0/2
Proxy
Host C
41
Receiver
Host B
VLAN 100
Figure 17. (Details not