HPE FlexNetwork 5510 HI Series Configuration Manual page 191

Configure the Anycast RP application so that the receiver-side DRs and the source-side DRs can
initiate a join process to their respective RPs that are topologically closest to them.
Configure the router IDs of Switch B and Switch D as 1.1.1.1 and 2.2.2.2, respectively. Set up an
MSDP peering relationship between Switch B and Switch D.
Figure 64 Network diagram
Receiver
Host A
Table 14 Interface and IP address assignment
Device
Source 1
Source 2
Switch A
Switch A
Switch B
Switch B
Switch B
Switch B
Switch B
Switch B
Configuration procedure
Assign an IP address and subnet mask to each interface, as shown in
1.
shown.)
Configure OSPF on the switches. (Details not shown.)
2.
Enable IP multicast routing, IGMP, and PIM-SM:
3.
# On Switch B, enable IP multicast routing.
<SwitchB> system-view
[SwitchB] multicast routing
Source 1
Switch A
Vlan-int300
Switch B
Vlan-int100
Loop10
MSDP peers
Interface IP address
— 10.110.5.100/24
— 10.110.6.100/24
Vlan-int300 10.110.5.1/24
Vlan-int103 10.110.2.2/24
Vlan-int100 10.110.1.1/24
Vlan-int103 10.110.2.1/24
Vlan-int101 192.168.1.1/24
Loop0 1.1.1.1/32
Loop10 3.3.3.3/32
Loop20 10.1.1.1/32
Source 2
Switch C
Vlan-int400
Switch D
Vlan-int200
Loop10
PIM-SM
Device
Switch C
Switch C
Switch D
Switch D
Switch D
Switch D
Switch D
Switch D
Switch E
Switch E
181
Switch E
Receiver
Host B
Interface IP address
Vlan-int101 192.168.1.2/24
Vlan-int102 192.168.2.2/24
Vlan-int200 10.110.3.1/24
Vlan-int104 10.110.4.1/24
Vlan-int102 192.168.2.1/24
Loop0 2.2.2.2/32
Loop10 4.4.4.4/32
Loop20 10.1.1.1/32
Vlan-int400 10.110.6.1/24
Vlan-int104 10.110.4.2/24
Figure 64. (Details not