HPE FlexNetwork 5510 HI Series Configuration Manual page 149

• VOD streams are sent to receiver hosts in multicast. The receiver groups of different
organizations form stub networks, and one or more receiver hosts exist on each stub network.
• The entire PIM domain operates in the dense mode.
• Host A and Host C are multicast receivers on two stub networks.
• IGMPv2 runs between Switch A and N1, and between Switch B, Switch C, and N2.
Figure 53 Network diagram
Source
10.110.5.100/24
Table 7 Interface and IP address assignment
Device
Switch A
Switch A
Switch B
Switch B
Switch C
Configuration procedure
Assign an IP address and subnet mask for each interface, as shown in
1.
shown.)
Configure OSPF on the switches in the PIM-DM domain. (Details not shown.)
2.
Enable IP multicast routing, IGMP, and PIM-DM:
3.
# On Switch A, enable IP multicast routing.
<SwitchA> system-view
[SwitchA] multicast routing
[SwitchA-mrib] quit
# Enable IGMP on VLAN-interface 100 (the interface that connects to the stub network).
[SwitchA] interface vlan-interface 100
Vlan-int300 Vlan-int101
Switch D
PIM-DM
Interface IP address
Vlan-int100 10.110.1.1/24
Vlan-int103 192.168.1.1/24
Vlan-int200 10.110.2.1/24
Vlan-int101 192.168.2.1/24
Vlan-int200 10.110.2.2/24
Switch A
Vlan-int100
Vlan-int200
Vlan-int101
Switch B
Vlan-int200
Switch C
Device
Switch C
Switch D
Switch D
Switch D
Switch D
139
Receiver
Host A
Host B
Receiver
Host C
Host D
Interface IP address
Vlan-int102 192.168.3.1/24
Vlan-int300 10.110.5.1/24
Vlan-int103 192.168.1.2/24
Vlan-int101 192.168.2.2/24
Vlan-int102 192.168.3.2/24
Figure 53. (Details not