Configuring Parameters For Mld General Queries And Responses - HPE FlexNetwork 5510 HI Series Configuration Manual

Configuration procedure
To enable the MLD snooping querier for a VLAN:
Step
Enter system view.
1.
Enter VLAN view.
2.
Enable the MLD snooping
3.
querier for the VLAN.
Configuring parameters for MLD general queries and
responses
CAUTION:
To avoid mistakenly deleting IPv6 multicast group members, make sure the MLD general query
interval is greater than the maximum response time for MLD general queries.
You can modify the MLD general query interval for a VLAN based on the actual network conditions.
A receiver host starts a report delay timer for each IPv6 multicast group that it has joined when it
receives an MLD general query. This timer is set to a random value in the range of 0 to the maximum
response time advertised in the query. When the timer value decreases to 0, the host sends an MLD
report to the corresponding IPv6 multicast group.
Set an appropriate value for the maximum response time for MLD general queries to speed up hosts'
responses to MLD general queries and avoid MLD report traffic bursts.
You can set the maximum response time for MLD general queries globally for all VLANs in
MLD-snooping view or for a VLAN in VLAN view. For a VLAN, the VLAN-specific configuration takes
priority over the global configuration.
Configuring parameters for MLD general queries and responses globally
Step
Enter system view.
1.
Enter MLD-snooping view.
2.
Set the maximum response
3.
time for MLD general
queries.
Configuring parameters for MLD general queries and responses in a VLAN
Step
Enter system view.
1.
Enter VLAN view.
2.
Set the MLD general query
3.
interval in the VLAN.
Set the maximum response
4.
time for MLD general queries
in the VLAN.
Command
system-view
vlan vlan-id
mld-snooping querier
Command
system-view
mld-snooping
max-response-time seconds
Command
system-view
vlan vlan-id
mld-snooping query-interval
interval
mld-snooping
max-response-time seconds
203
Remarks
N/A
N/A
By default, the MLD snooping
querier is disabled for a VLAN.
Remarks
N/A
N/A
The default setting is 10 seconds.
Remarks
N/A
N/A
The default setting is 125
seconds.
The default setting is 10 seconds.