HPE FlexNetwork 5510 HI Series Configuration Manual page 84

Figure 30 Network diagram
Switch A
Vlan-int300
50.1.1.1/24
50.1.1.100/24
Configuration procedure
Assign an IP address and subnet mask for each interface, as shown in
1.
shown.)
Configure OSPF on Switch B and Switch C. (Details not shown.)
2.
Enable IP multicast routing, and enable IGMP and PIM-DM:
3.
# On Switch C, enable IP multicast routing.
<SwitchC> system-view
[SwitchC] multicast routing
[SwitchC-mrib] quit
# Enable IGMP on the receiver-side interface (VLAN-interface 100).
[SwitchC] interface vlan-interface 100
[SwitchC-Vlan-interface100] igmp enable
[SwitchC-Vlan-interface100] quit
# Enable PIM-DM on VLAN-interface 101.
[SwitchC] interface vlan-interface 101
[SwitchC-Vlan-interface101] pim dm
[SwitchC-Vlan-interface101] quit
# On Switch A, enable IP multicast routing.
<SwitchA> system-view
[SwitchA] multicast routing
[SwitchA-mrib] quit
# Enable PIM-DM on each interface.
[SwitchA] interface vlan-interface 300
[SwitchA-Vlan-interface300] pim dm
[SwitchA-Vlan-interface300] quit
[SwitchA] interface vlan-interface 102
[SwitchA-Vlan-interface102] pim dm
[SwitchA-Vlan-interface102] quit
# Enable IP multicast routing and PIM-DM on Switch B in the same way Switch A is configured.
(Details not shown.)
Display RPF information for Source 2 on Switch B and Switch C.
4.
PIM-DM
Vlan-int102 Vlan-int102
30.1.1.2/24 30.1.1.1/24
Vlan-int200
40.1.1.1/24
Source 2
Static multicast route
OSPF domain
Switch B
Vlan-int101
20.1.1.1/24
Vlan-int101
20.1.1.2/24
Source 1 Receiver
40.1.1.100/24 10.1.1.100/24
74
Switch C
Vlan-int100
10.1.1.1/24
Figure 30. (Details not