Ipv6 Multicast Vlan Configuration Examples; Sub-Vlan-Based Ipv6 Multicast Vlan Configuration Example - HPE FlexNetwork 5130 EI Series Configuration Manual

Task
Display information about IPv6
multicast groups in IPv6 multicast
VLANs.
Display IPv6 multicast VLAN
forwarding entries.
Clear IPv6 multicast groups in IPv6
multicast VLANs.

IPv6 multicast VLAN configuration examples

Sub-VLAN-based IPv6 multicast VLAN configuration
example
Network requirements
As shown in
•
MLDv1 runs on Layer 3 device Switch A, and MLDv1 snooping runs on Layer 2 device Switch
B.
•
Switch A acts as the MLD querier.
•
The IPv6 multicast source sends IPv6 multicast data to IPv6 multicast group FF1E::101. Host A,
Host B, and Host C are receivers. They belong to VLAN 2 through VLAN 4, respectively.
Configure a sub-VLAN-based IPv6 multicast VLAN on Switch B to achieve the following goals:
•
Switch A sends the IPv6 multicast data to Switch B through the IPv6 multicast VLAN.
•
Switch B forwards the IPv6 multicast data to the receivers in different user VLANs.
Figure 32 Network diagram
Figure 32:
Command
display ipv6 multicast-vlan group [ ipv6-source-address |
ipv6-group-address | slot slot-number | verbose | vlan vlan-id ] *
display ipv6 multicast-vlan forwarding-table
[ ipv6-source-address [ prefix-length ] | ipv6-group-address
[ prefix-length ] | slot slot-number | subvlan vlan-id | vlan vlan-id ] *
reset ipv6 multicast-vlan group [ ipv6-group-address
[ prefix-length ] | ipv6-source-address [ prefix-length ] | vlan vlan-id ]
*
90