Ipv6 Multicast Routing And Forwarding Configuration Examples; Ipv6 Multicast Forwarding Over A Gre Tunnel - HPE FlexNetwork 5510 HI Series Configuration Manual

IPv6 multicast routing and forwarding
configuration examples

IPv6 multicast forwarding over a GRE tunnel

Network requirements
As shown in
• IPv6 multicast routing and IPv6 PIM-DM are enabled on Switch A and Switch C.
• Switch B does not support IPv6 multicast.
• Switch A, Switch B, and Switch C run OSPFv3. The source-side interface VLAN-interface 100
on Switch A does not run OSPFv3.
Configure the switches so that the receiver host can receive the IPv6 multicast data from Source.
Figure 82 Network diagram
IPv6 multicast router
Switch A
GE1/0/3
Vlan-int100
1001::1/64
Configuration procedure
Assign an IPv6 address and prefix length to each interface, as shown in
1.
shown.)
Configure OSPFv3 on the switches. Do not run OSPFv3 on VLAN-interface 100 on Switch A.
2.
(Details not shown.)
Configure a GRE tunnel:
3.
# On Switch A, create service loopback group 1, and specify the unicast tunnel service for the
group.
<SwitchA> system-view
[SwitchA] service-loopback group 1 type tunnel
# Assign GigabitEthernet 1/0/3 to service loopback group 1. (GigabitEthernet 1/0/3 does not
belong to VLAN 100 or VLAN 101.)
[SwitchA] interface gigabitethernet 1/0/3
[SwitchA-GigabitEthernet1/0/3] port service-loopback group 1
[SwitchA-GigabitEthernet1/0/3] quit
# Create a GRE tunnel interface Tunnel 2, and specify the tunnel mode as GRE/IPv6.
[SwitchA] interface tunnel 2 mode gre ipv6
# Assign an IPv6 address to interface Tunnel 2, and specify its source and destination
addresses.
[SwitchA-Tunnel2] ipv6 address 5001::1 64
Figure 82:
Vlan-int101
Vlan-int101
2001::1/64 2001::2/64
Tunnel0
5001::1/64
Source
Member port of a service loopback group
1001::100/64
IPv6 unicast router
Switch B
Vlan-int102
3001::1/64
GRE tunnel
247
IPv6 multicast router
Switch C
Vlan-int102
3001::2/64
GE1/0/3
Vlan-int200
4001::1/64
Tunnel0
5001::2/64
Receiver
4001::100/64
Figure 82. (Details not