HPE FlexNetwork 5510 HI Series Configuration Manual page 187

• According to the peer-RPF forwarding rule, the switches accept SA messages that pass the
filtering policy from its static RPF peers. To share multicast source information among PIM-SM
domains without changing the unicast topology structure, configure MSDP peering
relationships for the RPs of the PIM-SM domains and configure the static RPF peering
relationships.
Figure 63 Network diagram
AS 100
Receiver
Loop0
Switch A
Source 1
Table 13 Interface and IP address assignment
Device
Source 1
Source 2
Switch A
Switch A
Switch A
Switch B
Switch B
Switch B
Switch C
Switch C
Switch C
Configuration procedure
Assign an IP address and subnet mask to each interface, as shown in
1.
shown.)
Configure OSPF on the switches in the ASs. (Details not shown.)
2.
Enable IP multicast routing, PIM-SM, and IGMP, and configure PIM-SM domain borders:
3.
Vlan-int102
Vlan-int102
Switch C
Vlan-int103
Vlan-int100
Switch B
PIM-SM 1
BGP peers
Interface IP address
— 192.168.1.100/24
— 192.168.3.100/24
Vlan-int101 10.110.1.1/24
Vlan-int102 10.110.2.1/24
Loop0 1.1.1.1/32
Vlan-int101 10.110.1.2/24
Vlan-int100 192.168.1.1/24
Vlan-int103 10.110.3.1/24
Vlan-int102 10.110.2.2/24
Vlan-int200 192.168.2.1/24
Vlan-int104 10.110.4.1/24
AS 200
PIM-SM 3
Vlan-int106
Switch F
Receiver
PIM-SM 2
Switch D
Vlan-int103 Vlan-int105
Loop0
Source 2
Device
Switch D
Switch D
Switch D
Switch E
Switch E
Switch F
Switch F
Switch G
Switch G
Switch G
177
Switch G
Vlan-int106
Loop0
Switch E
Vlan-int105
Interface IP address
Vlan-int105 10.110.5.1/24
Vlan-int103 10.110.3.2/24
Loop0 2.2.2.2/32
Vlan-int105 10.110.5.2/24
Vlan-int300 192.168.3.1/24
Vlan-int106 10.110.6.1/24
Vlan-int104 10.110.4.2/24
Vlan-int106 10.110.6.2/24
Vlan-int400 192.168.4.1/24
Loop0 3.3.3.3/32
Table 13. (Details not