Quantum DXi4700 User Manual page 318

Chapter 9: Configuration
System
To install a file, click the Browse button to browse the system and locate the file, and then click Open.
Caution: Installing certificate files requires a system reboot immediately after the changes are
applied. Wait for at least 15 minutes before logging back in.
Note: You can install new certificate and key files at any time, as long as there are no active
network connections between the server and the DXi.
3. Click Apply.
Note: To clear all changes without saving them, click Reset. To remove user installed certificate
and key files, click Restore Factory Defaults.
Login Session
The Login Session page allows you to specify the inactivity timeout for the DXi4700 remote management
console. The default timeout is 30 minutes.
When the remote management console is inactive for the specified period of time, the user is automatically
logged off and must log back on to continue (see
To access the Login Session page, on the Security page, click Login Session (see
Figure 198: Login Session Page
To specify the inactivity timeout:
1. In the Inactivity Timeout box, enter the number of minutes of inactivity before a user is automatically
logged off (1–600 minutes).
2. Click Apply.
Security Notice
The Security Notice page allows you to specify a message that will appear to all users when logging on to
the remote management console or the CLI (command line interface).
If a security notice message has been specified, the user must accept the message in order to begin using
the system. If no security notice has been specified, the user can use the system immediately after logging
on.
To access the Security Notice page, on the Security page, click Security Notice (see
next page).
Quantum DXi4700 User's Guide
Accessing Remote Management on page 57).
Figure 198 below).
Figure 199 on the
318