Quantum DXi4700 User Manual page 135

Chapter 6: Replication
Replication Send
Directory/File or Cartridge Based Replication for the share or partition.
Or clear the Enable Directory/File or Cartridge Based Replication to target check box to disable
Directory/File or Cartridge Based Replication for the share or partition.
5. Enter a Sync ID in the box.
Additional Information
The Sync ID is used to identify the target share or partition that will receive replicated data from
l
the source share or partition. The Sync IDmust be identical to the Sync ID of the target share or
partition on the target system.
The Sync ID must contain no more than 32 characters (NAS share) or 12 characters (VTL
l
partition) and can contain only alphanumeric characters, underscores, and hyphens. (An
underscore or hyphen must not be the first character.)
If you are performing Directory/File or Cartridge Based Replication with a system running a DXi
l
software version prior to 2.3, you may need to change the Sync ID on the system running pre-2.3
software to match the above Sync ID name restrictions.
6. Select the check box for each replication target you want to replicate the share or partition to. (You must
select at least one target.) When the share or partition is replicated, its data will be sent to all selected
targets.
Note: Directory/File or Cartridge Based Replication will be configured for all selected targets. You
cannot configure one share or partition for multiple replication types.
7. Click Apply.
Note: After you configure a share or partition for Directory/File or Cartridge Based Replication, you
should synchronize it to ensure it is in sync with the target share or partition (see
or Partition on the next
Replicating a Share or Partition
Replicate a NAS share or VTL partition to send a snapshot of the share or partition to the target systems. A
snapshot is required to recover the data on the targets at a later time. If you have not configured a replication
schedule for a share or partition, replication only occurs when you manually initiate it (see ).
Caution: Do not replicate a partition containing media in an Exported state.
To replicate a share or partition:
1. Select the share or partition to replicate.
If multiple targets are configured, click the arrow next to the share or partition to display all targets, and
then select the desired target.
2. Click Replicate Now.
Quantum DXi4700 User's Guide
page).
Synchronizing a Share
135